Prodigy® Power Module
The Prodigy® Power Module (PPM) supports up to fifteen (15) Prodigy® master units and associated drone units. It provides the most economical and convenient method of powering multiple Prodigy® diffusers because electrician time is minimized. Designed to be ceiling mounted during any phase of a project, the enclosed 75 VA Class 2 transformer is offered for 115V or 277V primary voltage supply. Final power connections to the Prodigy® diffusers are completed via plenum cables with RJ (Snap-In) plugs. Since the cables are all low voltage, commissioning or relocation of Prodigy® diffusers is simple.

Features

• 96 VA Class Transformer with circuit breaker. Supports input voltages: (115VAC 60Hz, 240VAC 60Hz, 277VAC 60Hz, 480VAC 60Hz).
  Output voltage: 24 VAC.
• 6 parallel power jacks each of which support up to 6 Prodigy® units - any combination of masters and associated drones. Overload indicator LEDs on each line light up if too many Prodigy's are connected or if there is a short in the cable.
• C35 (35' plenum rated cable) with RJ plugs provides flexible and convenient power connection. One required for each master unit (order separately). Multiple cables can be connected by using a CC (Cable Connector) for longer runs.
• Power switch with indicator LED.

Prodigy® Pressure Relief Collar
The Prodigy® Pressure Relief Collar (PRC) provides a simple and inexpensive solution when duct pressures are higher than desired. When the Prodigy® responds to part-load requirements by reducing the airflow, the pressure at the Prodigy® inlet increases. The PRC’s dual shutters are designed to gradually open in response to pressures in excess of approx. 0.25" w.g. and allow some of the supply air to escape into the return air plenum. This decreases static pressure at the inlet, which reduces the risk of increased noise levels or excessive airflow. When the room cooling load increases, Prodigy® provides more airflow to the space and the PRC shutters gradually close. This minimizes energy waste while maximizing comfort.

The PRC is intended for use only in systems that have a non-ducted return air plenum.